There are a couple of options, but the most likely is setting
the site_root. It appears in _urlhandler.lasso and again in the
index.lasso as a safety.

var('siteroot')='/'; // adjust this so it reflects where the
site is located in the web root. Must begin and end with /.

// Specify the root path to this solution. The path should begin
and end with "/".
// Specify just "/" if the solution is at the virtual host root
instead of in a sub folder.
// Normally this is specified by the urlhandler if everything is
set up properly
if(!var_defined('siteroot'));
var('siteroot')=response_path;
/if;

--steve


On 10/15/10 at 3:36 PM, brianloomis1@mac.com (Brian Loomis) pronounced:

>I remember reading about a way to configure the filepaths that
>everything is looked for under and to be able to use custom
>folder names for the configurations but can't seem to find that now.
>
>Does anyone remember where in knop that is?
>
>Brian
>
>

-- -- -- -- -- -- -- -- -- -- -- -- -- -- -- -- -- -- -- -- --
-- --
Steve Piercy Web Site Builder
Soquel, CA
<web@StevePiercy.com> <http://www.StevePiercy.com/>


--
#############################################################
This message is sent to you because you are subscribed to
the mailing list <knop@lists.montania.se>.
To unsubscribe, E-mail to: <knop-off@lists.montania.se>
Send administrative queries to <knop-request@lists.montania.se>
List archive http://www.nabble.com/Knop-Framework-Discussion-f29076.html
Project homepage http://montania.se/projects/knop/
Google Code has the latest downloads at http://code.google.com/p/knop/